In the past, the bearing lubrication of high-line air-cooled rollers was thin oil lubrication or grease lubrication. Since there are thousands of lubrication points on the roller table, it is necessary to ensure that each lubrication point can be fully lubricated. Thin oil lubrication can only use multi-point progressive distributor intermittent lubrication. However, the iron oxide scale on the surface of the wire is blown into the air by the cooling fan of the air-cooled roller table or falls into the thin oil recovery tank to contaminate the oil. Oil contamination will increase the consumption of the filter element and cause clogging of the progressive distributor or strain on the surface of the filter element, reducing its service life, resulting in abnormal lubrication. In addition, in the dry oil method, due to the poor cooling effect of the dry oil, it cannot have a good cooling effect on the bearings, and a large amount of dry oil spilled will cause environmental pollution.
Some high-line air-cooled rollers in some steel plants now use thin oil lubrication or dry oil lubrication. Not only is it not suitable for the development of production, but frequent failures also lead to high bearing damage rates, which restricts production. When implementing
oil and gas lubrication transformation, technical reformers are faced with the specific problem of which company to find for implementation. Dopsel Company has many years of specific construction experience in high-line air-cooled roller table
oil and gas lubrication projects. As long as the customer can put forward specific modification requirements or what effect is to be achieved. Our professional and technical personnel can tailor the most suitable project content for customers.
No matter you have any questions in the oil and gas lubrication transformation of high-line air-cooled roller table
Dopse Company can give you a good answer.
News